TreeQuotesKnow the tree rules for your suburbCheck my tree

Victoria's canopy tree rules: when you need a permit to remove a tree on a residential block

Until September 2025, most Victorians could remove a tree without a permit unless their property had a planning overlay or their council had a tree local law. That changed when Clause 52.37 (Canopy trees) was added to every planning scheme in the state. It now needs a planning permit to remove, destroy or lop many larger trees on residential land, even where no overlay applies. The definition was changed again in September 2026, and a lot of advice online, including some council pages, still describes the old test.

General information only, not legal or planning advice. We read the current text of Clause 52.37 in the Victoria Planning Provisions and the state's guidance on 29 October 2026. Your council decides applications and can tell you how the rules apply to your tree, so check with it before any work starts.

The short answer

  • A canopy tree is a tree at least 5 metres tall with an average canopy at least 4 metres across. There is no longer a trunk-size test.
  • The permit applies in the Mixed Use, Township, Residential Growth, General Residential, Neighbourhood Residential and Housing Choice and Transport zones. It does not apply in the Low Density Residential Zone or in non-residential zones.
  • If there is a house on the block, only canopy trees with part of their trunk within 6 metres of the street frontage or 4.5 metres of the rear boundary need a permit under this clause. On a vacant lot, every canopy tree does.
  • Dead trees, the part of a tree that is an immediate risk, and light maintenance pruning are exempt.
  • Most applications are VicSmart, which the state says should be decided in 10 business days. Expect a condition to plant replacement canopy trees.
  • Overlays and council local laws still apply on top. Clause 52.37 is a minimum, not the whole answer.

What counts as a canopy tree now

The clause in force today defines an existing canopy tree as a tree with:

  • a height of at least 5 metres above ground level, and
  • an average canopy diameter of at least 4 metres.

To get the average canopy diameter, measure the distance between the widest points of the drip line (the outer edge of the foliage) in two directions at right angles to each other, then average the two. A tree 5 metres across one way and 3.5 metres the other averages 4.25 metres, so it counts.

Why older advice is wrong. When the clause started on 15 September 2025 (Amendment VC289), a canopy tree also had to have a trunk circumference of more than 0.5 metres, measured 1.4 metres above the ground. Amendment VC315, gazetted in September 2026, rewrote the definition without that trunk test. That means a tall, spreading tree with a slim trunk, which used to fall outside the rule, can now need a permit. The state's own guide page and several council pages still show the three-part test, so go by the clause itself, linked in the sources below.

Which properties it applies to

Clause 52.37 only needs a permit in six zones: the Mixed Use Zone, Township Zone, Residential Growth Zone, General Residential Zone, Neighbourhood Residential Zone and Housing Choice and Transport Zone. Most suburban house blocks in Melbourne and the regional cities sit in one of these. The Low Density Residential Zone is left out, and so are farming, rural, green wedge, commercial and industrial zones.

To find your zone, get a free property report for your address from VicPlan (mapshare.vic.gov.au). The same report lists any overlays, which you need to know about anyway (more on that below).

Which trees on the block need a permit

Where on the lot the tree stands matters as much as its size. The clause calls a canopy tree a boundary canopy tree if any part of its trunk is within 6 metres of the narrowest street frontage, or within 4.5 metres of the rear boundary.

Your situationCanopy trees that need a Clause 52.37 permit
Vacant lot (including a vacant lot where a single house needs only a building permit)Every canopy tree, anywhere on the lot
Existing house, no building work plannedBoundary canopy trees only
Existing house being extendedBoundary canopy trees only
Planning application for one or more new dwellings (units, townhouses)Boundary canopy trees need this permit. Other canopy trees are assessed as part of the development application and must not come down until that permit is issued.

So for a typical house with a big tree in the middle of the backyard, Clause 52.37 on its own does not need a permit. A tree in the front garden, or along the back fence, very often does. Measure from the trunk, not the canopy, and remember the front measurement is taken from the narrowest street frontage on a corner block.

Exemptions: when you do not need a canopy tree permit

The clause has a table of exemptions. The ones that matter to most homeowners are:

  • Dead trees. A dead canopy tree is exempt. Dying, leaning or dropping branches is not the same as dead, so take dated photos before anything comes down.
  • Immediate risk. Where a tree presents an immediate risk of personal injury or damage to property, the risky part can be removed or lopped. Only that part. If the whole tree needs to go once the danger is dealt with, that is a permit question. Our dead or dangerous tree guide covers getting this documented.
  • Maintenance pruning. Lopping or pruning for maintenance is exempt if no more than one third of the foliage is removed. It does not cover pruning the trunk, or pruning that would bring the tree under 5 metres tall or its canopy under 4 metres across. See tree lopping vs pruning for the difference.
  • Weeds. Trees declared as noxious weeds under the Catchment and Land Protection Act 1994, and trees your council has determined to be environmental weeds.
  • Fire protection and powerlines. Works to the minimum extent needed to comply with a fire prevention notice, keep a fuel break or fire access track (up to 6 metres wide in total), or keep trees clear of an electric line under the relevant code of practice. In designated bushfire prone areas, the separate bushfire exemptions in Clause 52.12 may also apply. Our bushfire clearing rules by state guide explains the Victorian 10/30 and 10/50 rules.
  • Public land. Work by or on behalf of a public land manager is exempt. Street trees belong to the council, not you, so ask the council rather than touching them.

These exemptions only switch off Clause 52.37. If an overlay or a local law also covers the tree, check its exemptions separately.

Overlays and local laws still apply

The state's guidance is clear that Clause 52.37 does not override or limit overlays or the bushfire rules. If your property report shows a Vegetation Protection Overlay, Significant Landscape Overlay, Environmental Significance Overlay or Heritage Overlay, that overlay can protect trees anywhere on the block, including smaller ones and ones in the middle of the backyard. Clause 52.17 separately protects native vegetation, and councils commonly apply it on lots over 4,000 square metres.

Council local laws are the other layer. The state says Clause 52.37 may override a local law only where the two duplicate each other, and the local law keeps operating for anything the clause does not cover. In practice:

  • Councils such as Boroondara, Kingston and Glen Eira have tree local laws that protect trees by size anywhere on private land, so a tree in the middle of the backyard can still need a local law permit there.
  • Councils such as Monash, Knox, Whitehorse and Maroondah rely on their planning schemes instead: Clause 52.37 plus overlays that cover large parts of each municipality.

Your council's page on our site lists what we have found for it, and the Victorian tree removal laws page has the statewide picture.

How to apply for a canopy tree permit

An application made only under Clause 52.37 is a class of VicSmart application. The state says VicSmart applications should be decided in 10 business days. Neighbours are not notified and cannot appeal the decision, but if the council refuses you can ask VCAT to review it. The clause says an application should include, as appropriate:

  • a site plan, photos or similar showing every canopy tree and other vegetation on the site, and the tree you want to remove, with its species, height and canopy diameter
  • an explanation of why the tree needs to be removed or lopped
  • details of the replacement canopy trees: species, expected height and canopy at maturity, soil conditions and irrigation
  • plans of the building or works, if the tree is coming out for construction
  • an assessment by a suitably qualified person if you want the tree removed because of its health or stability (see how to get an arborist report)

Council fees and lodgement portals differ. Some councils also limit how often you can use VicSmart for tree removal under their overlays (Monash and Whitehorse, for example, allow one VicSmart tree application in 12 months), so check your council's page before you lodge.

What the council weighs up

The council can only consider the decision guidelines in the clause itself. For a removal, these include:

  • the health and stability of the tree
  • whether it is causing, or at risk of causing, damage to a building, works or infrastructure
  • how many canopy trees will be kept on the site, and their size and location
  • whether canopy trees on the site have been removed or lopped in the past 12 months
  • its effect on things like driveways, easements, overhead power cables, sewer pipes, building foundations and solar access
  • in a designated bushfire prone area, the need for defendable space around the house

An arborist's assessment showing the tree is in poor health, structurally unsound or damaging a structure gives the council something concrete to weigh. “It drops leaves” on its own usually does not.

Replacement trees

Expect replacement planting. Monash, for example, says that in most circumstances a permit will be conditional on planting replacement canopy trees. The clause sets a target for the total canopy cover on the site, which can be met by keeping existing canopy trees, planting new ones, or both:

Site areaCanopy cover target
1,000 square metres or less10% of the site
Over 1,000 to 1,500 square metres15% of the site
Over 1,500 square metres20% of the site

A new canopy tree has to be a species expected to reach at least 6 metres tall with a canopy at least 4 metres across at maturity, planted in enough deep soil (at least 12 square metres for a tree with a 4 to 5 metre canopy). At least one canopy tree should be in the front setback. If your site has more than 20% cover already, the target is higher. Ask your council which species it suggests before you buy anything.

If you already had a permit before September 2025

Transitional rules cover some work that was already approved or underway before Amendment VC289, such as building under a building permit or planning permit issued before then, and some development plans. These rules are detailed, so ask your building surveyor or council rather than assuming the old position applies to you.

What happens if you remove one without a permit

Removing or lopping a canopy tree that needed a permit is a breach of the planning scheme, and councils can take enforcement action. Maroondah, for example, warns that removing a tree that does not meet an exemption may lead to enforcement action. The clause also lets a council consider canopy trees removed or lopped on the site in the past 12 months when it assesses a later application. The responsibility sits with the property owner, so “the tree guy said it was fine” is not a plan. A qualified arborist should ask about permits before quoting; see arborist vs tree lopper for what to check.

A quick checklist

  1. Get a free VicPlan property report and note your zone and any overlays.
  2. Measure the tree: is it 5 metres or taller, with an average canopy of 4 metres or more?
  3. Measure from the trunk to the street frontage and the rear boundary.
  4. Check whether an exemption applies, and photograph the tree either way.
  5. Check your council's overlays and any tree local law separately.
  6. If you need a permit, get an arborist's assessment if health or stability is the reason, then lodge.
  7. Do not book the removal until you have the permit, or written confirmation that you do not need one.

Our permit checker gives a quick first indication for your suburb, and is my tree protected? covers the other ways a tree can be protected. For prices, see tree removal cost.

Not sure if your tree needs a permit?

A local arborist can measure the tree, check where it sits against your boundaries and tell you whether the job is likely to need a permit before they quote. We are a free referral service, not arborists. Tell us about the tree and we'll put you in touch with local arborists for free, no-obligation quotes.

We're a free referral service, not an arborist. We collect these details only to match you with licensed arborists. See our Privacy Policy and Terms.

Frequently asked questions

What is a canopy tree in Victoria?

Under Clause 52.37 of the Victorian planning schemes, an existing canopy tree is a tree at least 5 metres tall with an average canopy diameter of at least 4 metres. The average canopy diameter is the average of the widest drip-line measurements taken in two directions at right angles. Since Amendment VC315 in September 2026 there is no trunk-size test, so older advice that mentions a 0.5 metre trunk circumference is out of date.

Do I need a permit to remove a tree in my backyard in Victoria?

If your land is in one of the residential zones Clause 52.37 covers and you already have a house on it, you need a planning permit for a canopy tree whose trunk is within 6 metres of the narrowest street frontage or 4.5 metres of the rear boundary. A canopy tree elsewhere in the backyard is not caught by Clause 52.37 unless you are applying to build new dwellings, but an overlay on your property or a council local law can still protect it. On a vacant lot, every canopy tree on the block is covered.

What are the exemptions under Clause 52.37?

The ones homeowners use most are: the tree is dead; only the part of a tree that presents an immediate risk of personal injury or damage to property; maintenance pruning that removes no more than one third of the foliage (but not trunk pruning, or pruning that takes the tree below 5 metres tall or a 4 metre canopy); declared noxious weeds and environmental weeds as determined by council; and listed fire protection and powerline clearance works. These exemptions only apply to Clause 52.37, not to overlays or local laws.

Can I remove a dead tree without a permit in Victoria?

A dead canopy tree is exempt from the Clause 52.37 permit. Overlays and local laws have their own rules, and some protect dead native vegetation, for example Clause 52.17 on larger lots. Take dated photos before the tree comes down and keep them, because a tree that is dying or leaning is not dead.

How long does a canopy tree permit take?

An application made only under Clause 52.37 is a VicSmart application, and the state says VicSmart applications should be decided in 10 business days. Neighbours are not notified and cannot appeal. If the council refuses, the applicant can ask VCAT to review the decision. If your tree is also covered by an overlay or a local law, that part can take longer.

Does Clause 52.37 replace my council's tree local law?

No. The state says Clause 52.37 may override a council local law only where the two cover the same thing, and the local law keeps working for anything beyond the clause. Councils such as Boroondara, Kingston and Glen Eira protect trees by size under their own local laws, so you may need both a planning permit and a local law permit.

Sources

We use essential cookies to run this site and, with your consent, analytics cookies to improve it. See our cookie policy.